ASE Electrical

Front

When using a DMM (Digital Multimeter) voltmeter function to check for a voltage drop, meter leads should be connected in which of the following ways? a. On the "positive" side of the circuit, b. Across the component or circuit, c. To any non-conductive material, d. In series with the circuit

Back

Across the component or circuit

Front

Which of the following is correct regarding a series circuit? a. Highest resistance has most current. b. Lowest resistance has most current. c. Lowest resistance has highest voltage drop. d. Highest resistance has highest voltage drop

Back

Lowest resistance has most current.

Front

When a Digital Multimeter (DMM) is used to measure DC voltage and is connected in parallel to the load device, which of the following defines the reading? a. Amperage reading, b. Voltage drop, c. Voltage spiked, d. Pulse width modulation

Back

Voltage drop.

Front

Technician A says a loose serpentine alternator drive belt could cause overcharging. Technician B says undersized wiring between the alternator and the battery could cause undercharging. Who is right?

Back

Technician B

Front

The main task of battery in automobile is to

Back

Supply a large amount of power to turn the starter motor when the engine is being started

Front

What is this symbol for? (Options: light bulb, switch, battery, resistor)

Back

battery

Front

Back

Switch (open)

Front

Back

Switch (Closed)

Front

Back

Diode

Front

The term that tells us the size (diameter of a wire)

Back

Gauge