Dimensioning Multiview Drawings Review

Front

Which of the following is not a type of dimensioning system used on technical drawings in the U.S.:
fractional dimensioning, metric dimensioning, decimal-inch dimensioning, proportional dimensioning

Back

proportional dimensioning

Front

The dimensions of a multiview drawing are referred to as: width, height, depth

Back

width, height, depth

Front

What are the three principal surface planes in orthographic projection?

Back

top, front, right side

Front

The maximum number of views possible in orthographic projection are?

Back

6

Front

What rule describes the use of views in orthographic projection?

Back

use just enough views to describe the part or object completely

Front

Most multiview drawings are described by how many views?

Back

3

Front

Which of the following is the correct order to follow when laying out dimensions for an object?
place light layout lines, draw in light guidelines, darken extension lines, add arrowheads
draw in light guidelines, place light layout lines, darken extension lines, add arrowheads
draw in light guidelines, darken extension lines, place light layout lines, add arrowheads
place light layout lines, add arrowheads, draw in light guidelines, darken extension lines

Back

place light layout lines, draw in light guidelines, darken extension lines, add arrowheads

Front

The front view of a multiview projection shows which two dimensions?

Back

height and width

Front

The top and right side views have what common dimension(s)?

Back

depth

Front

This scale is designed to measure in feet, inches, and fractions of an inch.

Back

architect’s