2018 IFGC CH 3A Study Flashcard

Front

Unless otherwise approved in accordance with Section 105, appliances regulated by this code shall be __________.

Back

listed

Front

Unlisted appliances__________.

Back

may be approved based upon an approved engineering evaluation.

Front

For a label affixed to a listed fuel gas appliance, which of the following is not required information? a. The appliance Btu/hour rating, b. If the appliance is rated for 120 or 220 volt alternating current, c. The approved fuel, d. The minimum required clearances, Reference Section(s): 301.5

Back

If the appliance is rated for 120 or 220 volt alternating current

Front

Combustion air requirements for appliances with power burners are determined by _____________.

Back

the manufacturer’s instructions

Front

Conversion of an appliance to a different fuel gas is allowed if in accordance with the _____________ instructions.

Back

manufacturer’s

Front

Appliances in structures located in flood hazard areas shall be located at or above the _______________.

Back

elevation required by the IBC

Front

Notching at the ends of wood joists shall not exceed ___________the joist depth.

Back

¼

Front

Cuts, notches and bored holes are prohibited in trusses except where___________.

Back

the effects are specifically considered in the design.

Front

In bearing partitions, any wood stud is permitted to be cut or notched to a depth not exceeding_________________ percent of its width.

Back

25

Front

Notches in the flange of a cold-formed steel stud in a bearing wall ___________.

Back

are not allowed