CH 57 Short Block Rebuilding & Machining

Front

Who is right regarding short block service: Technician A says checking for main bore and deck warpage is a typical procedure, while Technician B says cylinder head milling is common?

Back

Tech A Only

Front

Which of the following problems should you look for when inspecting a cylinder block? Cylinder Ring Ridge, Cylinder Scoring, Cracked Cylinder, All of the above

Back

All of the above

Front

Who is right regarding the measurement methods: Technician A says that the block deck warpage is measured with a straight edge and feeler gauge. Technician B says that cylinder wear is measured with an inside micrometer and dial indicator?

Back

Both Technician A & B

Front

Cylinder taper is the difference in cylinder diameter when measured........

Back

At the top and bottom

Front

What is the purpose of deglazing a cylinder?

Back

to promote proper ring seal

Front

How do we locate cracks in aluminum blocks?

Back

fluorescent dye and black light

Front

Why are piston ring end gaps spaced apart from each other?

Back

helps to prevent crankcase blow by and sealing

Front

What tool should be used to check piston diameter?

Back

an outside micrometer

Front

Cylinders are normally measured in fractions of an inch

Back

in thousandths of an inch

Front

To inspect crankshaft journals, they should be....

Back

all of the above