Core introduction to construction drawings

Front

Revisions to the drawing are entered in the revision block and must include: The project tag and the date the drawing was approved, engineering approvals and the intended date of completion, the date and the initials of the person who made the revision, dates and signatures for customer approval documentation.

Back

The project tag and the date the drawing was approved.

Front

Code books and specifications for a construction project often include the meanings of

Back

symbols

Front

When a plan is marked NTS, the dimensions as measured on the drawing cannot be used to build the project.

Back

True

Front

What is the length in feet and inches of the section of duct using the architect's scales shown in Figure SR01?

Back

6 feet, 5 inches

Front

A site plan__________

Back

shows the location of the building from an aerial view

Front

When the metric system is used, dimensions are written in

Back

meters, centimeters, and millimeters

Front

If the scale on a site plan reads SCALE: 1'=20' 0", then every __________

Back

an inch on the drawing represents 20 feet, 0 inches

Front

What is the length in meters at the point indicated by the arrow on the metric scale in figure RQ01? The unit of length used on the scale is the meter.

Back

3.5

Front

An engineer's scale is set up in multiples of ________

Back

10

Front

Which type of plan shows the layout of the HVAC system? Options: Plumbing, Structural, Mechanical, Foundation

Back

Mechanical