Ag. Mechanics 1 Unit 4.04-4.05

Front

When Sheri is framing a building, sills are installed:

Back

first

Front

Because extra strength is needed for support, most framing lumber used for wood buildings should be:

Back

2" thick.

Front

When Jan uses platform-type framing, where is the top plate attached?

Back

on top of the studs

Front

When a carpenter frames a building using platform framing, the floor joist header is installed:

Back

second.

Front

Trimmer studs for doors are installed:

Back

on each side.

Front

What are the horizontal parts of a building’s framing to which the studs are attached?

Back

plates

Front

What framing part should a carpenter nail to both the top plate and the sole plate?

Back

stud

Front

If one is unable to use a rafter table, the length of a common rafter can be determined by using the: bird’s-eye, estimating method, ridgeboard, stepping method.

Back

stepping method.

Front

If a builder uses precut studs for platform-type framing, the lumber needed for a door header is two pieces measuring:

Back

2" × 10".

Front

When lumber is used for the horizontal parts of framing, where should the crown of a warped board be located?

Back

top