CEA 1st Semester 2024

Front

Which best describes a function of an architect? Options: Legally represent the buyer in acquiring the property for a new building. Determine the correct type of building foundation for the soil conditions. Arrange interior space in order to create efficient traffic patterns. Specify the pipe size and location of water and sewer lines for new construction.

Back

Arrange interior space in order to create efficient traffic patterns.

Front

What style of architecture is often characterized by a balanced and symmetrical design, entry porch with columns, low pitched roof, fanlight over front door, double hung windows, and dentil molding, such as Thomas Jefferson’s Monticello?

Back

Federal

Front

What architectural style would best describe the structure in the picture?

Back

Tudor

Front

What roof shape would best describe the roof of the house in the picture? Options: gable, gambrel, mansard, shed

Back

gambrel

Front

With horizontal beams placed across vertical posts, the Parthenon is an example of construction.

Back

Post-and-lintel

Front

Which room is most likely drawn incorrectly on the (residential structure) bubble diagram? Options: Office, Bedroom, Bathroom, Living Room

Back

Bathroom

Front

Choose the feature which would NOT appear in a good floor plan: Short hallways that do not extend to an exterior wall, A closet near the main entry door, Many small rooms for different functions., A entry from the garage into the kitchen

Back

Many small rooms for different functions.

Front

Using the information provided in the R-Value and Densities chart, which insulation choice has the lowest U factor? Options: 3.5 inches of batt insulation, 3.5 inches of rigid board polystyrene, 5.5 inches of batt insulation, 5.5 inches of rigid board polystyrene

Back

5.5 inches of rigid board polystyrene

Front

Given the information in the table, what is the minimum R-value that will result in a total heat transmission load of 628.5 Btu/hr?

Back

Front

If the inside and outside air films are neglected, what is the R-value for the wall assembly shown in the diagram?

Back