ASE G1 practise test

Front

One of the vehicle's brake lights is inoperative. All other lights are functioning normally. What should be checked first?

Back

The bulb

Front

A hydroboost brake system has a hard brake pedal and reduced braking performance. What could cause this condition?

Back

Aerated power steering fluid

Front

The TPMS warning light goes out after driving the vehicle for several miles. What is the most likely cause?

Back

Low tire air pressure

Front

A rear-wheel-drive vehicle with an automatic transmission has a vibration that increases with vehicle speed and a loud clunk when shifted from park to drive or reverse. What is causing this condition?

Back

Loose and worn universal joints

Front

An oil filter has ballooned on a four-cylinder engine. Who is correct? Technician A says a stuck closed oil filter bypass valve would cause this swelling. Technician B says a stuck open oil pressure valve would cause this swollen filter.

Back

Technician A

Front

A technician measures several spots around a brake rotor with an outside micrometer. Technician A says the technician is checking the rotor for thickness variation. Technician B says the technician is checking the rotor for lateral runout. Who is correct?

Back

Technician A

Front

The brake fluid in an ABS system has become aerated, resulting in a spongy brake pedal. Which brake fluid has caused this condition?

Back

Dot 5 brake fluid

Front

Who is correct regarding the thermostat's role in engine performance and temperature control?

Back

Both A and B

Front

Who is correct when replacing a halogen bulb in a headlight system? Technician A: Handle the bulb with added space during installation. Technician B: Wear gloves or use a piece of paper when handling the glass portion.

Back

Both A and B

Front

All of the following are true about testing engine coolant EXCEPT: An antifreeze hydrometer indicate's the boiling point, An antifreeze refractometer displays the percentage of coolant to water, An antifreeze test strip indicates the coolant's PH balance, The engine must be brought to operating temperature before testing the coolant's boiling point

Back

The engine must be brought to operating temperature before testing the coolant's boiling point