051 C&G flashcard

Front

When working on electric hand tools what safety inspection should always be completed before using them?

Back

The electric cable is not frayed and damaged.

Front

Which one of the following is a danger when working with hybrid and electric vehicles in the motor vehicle workshop?
Options:
Earmuffs must be worn due to the excess noise.
The vehicle bodywork is always positively charged.
They can be silent when driving in the workshop.
A push button is used when starting and power up.

Back

They can be silent when driving in the workshop.

Front

When following Control of Substances Hazardous to Health (COSHH) regulations, which one of the following does it apply to? Hand tools, Electric lifting equipment, Air-line pressure, Brake fluids

Back

Brake fluids

Front

Why must a High Voltage Hybrid type vehicle not be left powered up and the lights left on in the workshop?

Back

The internal combustion engine may start up itself.

Front

Why is it important not to leave the ignition key/card closer than 2 metres to the car when not working on the vehicle?

Back

In case the vehicle identifies the signal and powers up

Front

Who is responsible for maintaining health and safety in the workshop?

Back

All staff

Front

How should old used tyres and waste oil be disposed of in the garage environment?

Back

Removed from site by registered waste operators

Front

Where chrome is starting to peel off a combination spanner, what risk does this give to the technician?

Back

The chance the chrome will cut the skin.

Front

What may happen to a coiled-up mains voltage extension cable when it is being used in the workshop?

Back

The cable may get very hot.

Front

Why should a chisel with the turned over mushroom effect be ground down before use?

Back

To prevent flying particles coming off