EOC Practice 2025 1

Front

The design firm would like to adjust the tolerance from +/- .05 to +/- .005. They should expect the manufacturer to ...

Back

increase the per unit cost

Front

Given a tolerance range for the diameter of a hole, which would yield the MMC (Maximum Material Condition)?

Back

smallest allowed diameter

Front

Provide Ohm’s Law I = V / R. If Voltage = 12 V and Resistance = 50 ohms, find the current?

Back

0.24 A

Front

What is this item called?

Back

Resistor

Front

How difficult it is for current to flow through a component is referred to as Resistance. What unit is Resistance measured in?

Back

Ohms

Front

Current is the flow of electricity, which unit is used to measure this flow?

Back

Amperes (amps)

Front

Determine the width of the object.

Back

44

Front

Determine the depth of the object.

Back

30

Front

Factors that limit or restrict a design, such as having limited amount of money or time is called

Back

constraints

Front

Choose the Unilateral Tolerance Note

Back