NCCER CORE: Hand Tools

Front

Another name for a machinist's hammer is___

Back

ball-peen hammer

Front

What wrench is shown in the figure?

Back

box-end

Front

The type of screw shown in the figure above is a(n)___

Back

Torx

Front

Which Pliers are used to get into narrow places where other pliers cannot reach?

Back

long-nose

Front

What is a characteristic of a pipe clamp?

Back

a length of pipe for a spine

Front

How does a traditional spade differ from round and square shovels?

Back

is flatter and without curved sides

Front

What pliers are these in the figure?

Back

linesman/side cutters

Front

What are three special markings on a folding rule?

Back

16" 19.2 " 24"

Front

When sawing lumber, where should the kerf be when beginning the cut? Options: to the right of the dominant hand, to the left of the dominant hand, on the measured side of the marked line, on the scrap side of the marked line

Back

on the scrap side of the marked line

Front

One situation that can make a measurement with a laser inaccurate is measuring to a ___

Back

highly reflective surface