AMTBLK06 Final A

Front

What terms are used when two waveforms go through their maximum and minimum points at different times to describe the phase difference?

Back

lead and lag

Front

The phase shift created by inductive reactance always causes voltage to

Back

lag current

Front

Identify the choice that best completes the statement or answers the question. An example of SWAMP area for aircraft wiring

Back

near wing flaps, wing folds, or pylons

Front

Whenever troubleshooting aircraft electrical circuits, it is always valuable to consider Ohm’s Law: remembering that a low resistance means increased current and can explain why circuit breakers pop or fuses blow

Back

Ohm’s Law states that current is directly proportional to voltage and inversely proportional to resistance.

Front

Which wire type can be severely damaged on the inside without any evidence of damage on the outside? PTFE wiring, ETOPS wiring, coaxial cable

Back

PTFE wiring

Front

Identify the choice that best completes the statement or answers the question. While starting the engine the starter can often draw 100 or more amperes, for this reason, a.

Back

all starter motors are controlled through a solenoid

Front

The Altitude Encoder converts the aircraft’s pressure altitude to a code and sends it to ATC from the transponder when selected to ALT. This system works between the altitudes of: 1000 feet MSL- 40,000 feet MSL, 1200 feet MSL- 100,000 feet MSL, 1200 feet MSL-126,700 feet MSL.

Back

1000 feet MSL- 40,000 feet MSL

Front

What BUS is directly connected to the battery?

Back

hot battery bus

Front

Why is it important for technicians to be aware of correct orientation of the ADF antenna?

Back

placement of ADF antenna is critical to a correct indication since it is a directional device

Front

What device will aid the pilot to intercept the ILS to enable its use?

Back

Radio Magnetic Indicator