LV08 Chassis A

Front

What type of output signal do most inductive type sensors produce when tested with an oscilloscope?

Back

A Sine Wave

Front

When the ABS system begins to operate, what is the first pressure phase called?

Back

Holding Phase

Front

ABS

Back

Anti Lock Brake System

Front

Excessive pulsating of the brake pedal when the brakes are applied could be caused by: Options: Excessive brake disc run-out, Drums out of round ,Loose brake drum, Loose wheel bearing , All options

Back

All options

Front

What type of signal is being received by the electric power steering ECU?

Back

Pulse width Modulation (PWM)

Front

What causes a spongy brake pedal?

Back

Air in the hydraulic brake system

Front

Non-progressive brake operation could be caused by:

Back

Faulty valve in the brake servo.

Front

On braking, the ABS system goes into operation, it will go in to pressure holding phase first, the next phase it will go in to is called:

Back

Pressure reduction phase

Front

The diagram shows the layout of a communication network from a light vehicle. This type of system is referred to as.

Back

A CAN BUS system, Multiplex

Front

The metal strip identified as X on the brake pad is the:

Back

Brake pad wear indicator.