Untitled Flashcards

Front

Refer to the exhibit. Which prefix does Router1 use for traffic to Host A?

Back

10.10.13.208/29

Front

Which 802.11 frame type is Association Response

Back

management

Front

What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)

Back

when one side of the connection is configured for half-duplex

when the cable length limits are exceeded

Front

Which action is taken by switch port enabled for PoE power classification override?

Back

Should a monitored port exceed the maximum administrative value for power, the port is shut down and err-disabled

Front

Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface

Back

enable SLAAC on an interface

Front

What are two differences between optical-fiber cabling and copper cabling? (Choose two.)

Back

The glass core component is encased in a cladding

Light is transmitted through the core of the fiber

Front

Which IPv6 address block forwards packets to a multicast address rather than a unicast address?

Back

FF00::/12

Front

Which type of IPv6 address is publicly routable in the same way as IPv4 public addresses?

Back

global unicast

Front

A corporate office uses four floors in a building.

Floor 1 has 24 users.

Floor 2 has 29 users.

Floor 3 has 28 users.

Floor 4 has 22 users.

Which subnet summarizes and gives the most efficient distribution of IP addresses for the router

configuration?

Back

192.168.0.0/25 as summary and 192.168.0.0/27 for each floor

Front

Back

10.10.225.32 255.255.255.224