TLE 9 CSS Q1 WEEK 1 DAY 2

TLE 9 CSS Q1 WEEK 1 DAY 2

by Mam Jonalyn Rosario

Quality of Received materials​

​WEEK 1

​Objectives

​Obtain work instruction in accordance with the standard operating procedures.

​

Check the received materials against workplace standards and specifications

Identify and isolate faulty materials related to work

​

​The student must relate material properties to product and process quality.

These are the factors that must be taken into consideration when choosing the right material for their components and assemblies:

​1. Selection of Material

• ​Material selection is one of the most common tasks for design engineering. The ability to assess the material’s impact on the performance of a product is crucial for reliable performance.

2. Testing of material

• ​The testing of material properties is widely understood to be the key to obtaining data for a project, performing failure analysis, or understanding material interactions. Material testing also provides information on the quality of incoming and outgoing products

3. Cost of material

• ​The cost of material is also considered when buying or selecting materials for a specific project. The amount may vary but never taken for granted the quality and the reliability of the material. Will you buy material which is less expensive but worst quality? Will you buy material which you cannot afford?

Multiple Choice

The following are the factors to be considered when choosing the right materials EXCEPT.

• Received Material

• Selection of material

• Testing of material

• Cost of material

Multiple Choice

The characteristics of the materials to be used for specific project must be

• low cost

• of good quality

• reliable

• suitable for the application/ purposes

• all of the above

​Fault Identification and Reporting

1. ​R E C E I V I N G M _ T _ R I _ L S

2. ​R E C E I V I N G R E P _ R _ S​

3. ​​R E T U R N O F _ E R C H A N _ I S _

4. ​M A K E A N I N V E N T O R Y O F R E _ O _ T S