Sterile Processing IV & Compounding Review: Theory 3-6

Which is not an area addressed by USP 797?

• Expiration Dates
• Avoiding drug interactions
• Environmental quality & control
• Contamination risk levels

If _____________ are worn in a clean room they must be covered with a lab coat or gown at all times even when they are not in the clean room.

• Gloves
• Mask
• Scrubs
• Shoe Covers

Whenever ________ agents are stored in the same refrigerator, they must also be labeled and separated from other drugs.

•   Chemotherapy drugs
•   Hazardous drugs
•   Cytotoxic
•   All the above

An administration set is required for an IV solution to be infused.

• True
• False

A ___________ is used to puncture the rubber diaphragm located inside the administration set.

• Drip Chamber
• Additive Port
• Needle Adaptor
• Spike

A __________ is the clean zone where all sterile compounding manipulations should be performed.

• High Efficiency Particulate Air Filter (HEPA)
• Pre Filter
• Work Surface
• All of the above

When working in a horizontal laminar airflow hood, all manipulations should be performed at least _______ inches within the hood to prevent contamination of mixed air.

• 3
• 4
• 5
• 6

The horizontal flow hood should be left on at all times to assure proper aseptic conditions . If turned off, the hood should be allowed to run at least ___________ minutes prior to use.

• 10
• 15
• 30
• 45

A ________ is used to prevent the introduction of particulate matter.

• Filter Device
• Needle Adaptor
• Roll Clamp
• None of the above

The Additive Port is used to regulate the rate of infusion.

•   True
•   False