R&S Ch 3

Which dynamic routing protocol was developed to interconnect different Internet service providers?

• BGP
• EIGRP
• OSPF
• RIP

Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?

• OSPF
• RIP
• EIGRP
• IS-IS

Which task does dynamic routing protocols perform? 

• propagate host default gateways
• update and maintain routing tables
• discover hosts
• assign IP addressing

Which task does dynamic routing protocols perform? 

• propagate host default gateways
• network discovery
• discover hosts
• assign IP addressing

When would it be more beneficial to use a dynamic routing protocol instead of static routing?

• in an organization with a smaller network that is not expected to grow in size
• in an organization where routers suffer from performance issues
• on a network where there is a lot of topology changes
• on a stub network that has a single exit point

When would it be more beneficial to use static routing instead of dynamic routing protocols?

• on a network that is expected to continually grow in size
• on a network that has a large amount of redundant paths
• on a network that commonly experiences link failures
• on a network where dynamic updates would pose a security risk

What is a purpose of the network command when configuring RIPv2 as the routing protocol?

• It specifies the remote network that can now be reached.
• It identifies the interfaces that belong to a specified network.
• It immediately advertises the specified network to neighbor routers with a classful mask.
• It populates the routing table with the network entry.

A network administrator configures a static route on the edge router of a network to assign a gateway of last resort. How would a network administrator configure the edge router to automatically share this route within RIP?

• Use the passive-interface command.
• Use the auto-summary command.
• Use the network command.
• Use the default-information originate command.

What is the purpose of the passive-interface command?

• allows a router to send routing updates on an interface but not receive updates via that interface
• allows a router to receive routing updates on an interface but not send updates via that interface
• allows an interface to remain up without receiving keepalives
• allows interfaces to share IP addresses

Which route would be automatically created when a router interface is activated and configured with an IP address?

• C  192.168.0.0/24 is directly connected, FastEthernet 0/0
• D  10.16.0.0/24 [90/3256] via 192.168.6.9
• S  192.168.1.0/24 is directly connected, FastEthernet 0/1
• O  172.16.0.0/16 [110/65] via 192.168.5.1