Safety Test: Table Saw

The top of this saw looks like a _____________

• Board 
• Table 
• Construction site 
• Iron

Do not remove small ___________ while the saw is running.

• Tools 
• Nails 
• Scraps 
• Miters 

When rip cutting you must use a _________ if the cut board is less than 4 inches wide. 

• Screwdriver
• Rammer
• Trick brick 
• Push stick 

When ripping a board you should NEVER ________ on a board until is it completely past the blade. 

• Release 
• Repeat 
• Cut 
• Throw 

When you are HELPING rip a board you should NEVER __________ on a board, only catch. 

• Paint 
• Push or Pull
• Throw
• Jump 

You should stand to the right or _________ of the board being ripped. 

• Top 
• Up side
• Left
• Middle 

For safety, you should never rip a board less than ________ inches wide. 

• 2
• 1/4 
• 8 
• 1/2

The shortest piece of wood you can rip is ___________ long. 

• 20 
• 48
• 10 
• 5

A rip fence should NEVER be used to ____________ board. 

• Cross-cut 
• Resaw-cut 
• Free-cut 
• Joint-cut 

When using the MITER GAUGE the board being cut should always be long enough to ___________ the miter gauge. 

• Trim 
• Cover
• Cut
• Gauge