Introduction to Material Handling

__________________________________ can be found in two,three and four roller versions and are used to move heavy loads to the pallet .-

• Roller skids

• Mover plates

• Jack plates

• Dolly roller

This type of knot would be referred to as a ____________________________________________.

• Square knot

• Bowline

• Clove hitch

• Double knot

This would be an example of a ______________________________ .

• Slip knot

• Bowline knot

• Square knot

• Clove hitch knot

This is an example of a _________________________________ .

• Slip knot

• Bowline knot

• Square knot

• Clove hitch knot

The outlined zone behind the forklift would be known as the _______________________________________ .

• Work zone

• Danger zone

• Radius zone

• Hot zone

This would be an example of a ___________________________ knot .

• Slip knot

• Bowline

• Square

• Double

_____________________________ is to change the form and rearrange the parts of a knot ,usually by pulling on specific ends of thr knot.

• Capsize

• Standing part

• Working end

• Half hitch

Operators are required to have at least one ________________ all times when moving loads or heavy equipment in a work zone.

• Hand on the wheel

• Oiler

• Spotter

• Project engineer

What are the three types of forklift steering options ?

• Crab,diagonal,and all wheel

• All wheel, crab,and front only

• Three wheel, four wheel, and two wheel

• Self, automatic and manual

The device shown in the picture would be called a ___________________________ ?

• Pipe dolly

• Pipe transport

• Tool carrier

• Hand truck