Auto Technology Suspension ASE

Name this component

• Ball joint
• tie rod end
• control arm 
• socket

Name this component

• radius arm
• control arm
• strut
• steering rack

Name this component

• u bolt
• leaf spring
• sway bar

Name this component 

• Strut
• shock
• coil spring 

Name this component

• control arm
• sway bar 
• steering knuckle 

Which angle does not affect tire wear?

• caster
• camber 
• toe

Technician A says a vehicle will pull to the side with the most positive camber. Technician B says that too much negative camber will result in excessive wear on the inside tread of the tire. Who is correct?

• Technician A only
• Technician B only
• Both Technician A and B
• Neither Technician A nor B

Two technicians are discussing inner and outer tie rods. Technician A says to turn the outer tie rod end to adjust the toe. Technician B says loose inner tie rod ends will cause a tire to feather. Who is correct?

• Technician A only
• Technician B only
• Both Technician A and B
• Neither Technician A nor B

On cold mornings, the warning lamp on a vehicle with a TPMS tire pressure monitoring system stays illuminated for several minutes before it goes out. Which of these is MOST likely the cause of this condition.

• Clogged TPMS sensor.
• Worn tread on one of the tires.
• TPMS initialization.
• Low tire pressure.

Two technicians are performing a power steering pressure test. Technician A says a restriction in the high pressure line results in higher than normal test results. Technician B says if the pressure increases when the shutoff valve is closed, there's a problem with the power steering pump. Who is correct?

• Technician A only
• Technician B only
• Both Technician A and B
• Neither Technician A nor B