Chapter 4 AutoCAD

When you draw a circle using the 2-Point option, the two points you select define the circle’s ____.

• circumference

• diameter

• radius

• volume

Which of the following commands does not display a rubberband line while the command is active?

• CIRCLE

• ERASE

• LINE

• POLYLINE

Which of the following is not a valid option for creating a circle?

• 1-POINT

• 3-POINT

• CENTER, DIAMETER

• TAN,TAN, RADIUS

Which of the following options allows you to draw a circle tangent to three existing objects?

• 2-Point

• Center, Diameter

• Tan, Tan, Radius

• Tan, Tan, Tan

Which of the following is not a valid option for creating an arc?

• START, CENTER, END

• 3-POINT

• START, END, RADIUS

• CENTER, RADIUS

If you know that an arc with an included angle of 15° needs to begin at the end of an existing line and end at the center point of a circle, which ARC option would you use to create the arc?

• START, CENTER, ANGLE

• START, CENTER, LENGTH

• START, END, ANGLE

• START, END, RADIUS

The two axes of an ellipse are known as the ____ axes.

• INNER AND OUTER

• MAJOR AND MINOR

• STARTING AND ENDING

• UPPER AND LOWER

To create an octagon using the POLYGON command, how many sides should you specify?

• 8

• 4

• 5

• 6

A small angled surface used to relieve a sharp corner is known as a ____.

• ROUND

• TANGENT

• FILLET

• CHAMFER

A rounded interior corner is known as a ____.

• ROUND

• TANGENT

• FILLET

• CHAMFER