Carpentry II - Exterior Finishing

The most common exterior finish is ____ siding.

• brick
• wood
• vinyl
• aluminum

The type of beveled wood siding that has a single rabbeted edge is known as ____.

• bungalow
• channel rustic
• T&G
• Dolly Varden

The primary purpose of flashing is to ____.

• allow the use of the most cost- effective interior construction
• provide protection from the elements
• prevent the entry of water
• provide a base for the final finish

When carrying plywood or other sheet material on a windy day, you should

• carry it over your head

• carry it so the edge of the sheet points to the wind

• make sure the veneer side is facing into the wind

• carry is so any flat surface faces into the wind

The bottom of an extension ladder should be set back one foot for

• each foot of ladder length

• each two feet of ladder length

• each three feet of ladder length

• each four feet of ladder length

EIFS means

• exterior/interior framing stud

• exterior insulation and finish system

• extended/ integrated fascia and soffit

• exterior insulation framing system

A vertical siding in which narrow boards overlap wider boards underneath is called

• board-and-batten

• reverse batten

• board-on-board

• shiplap

The finish recommended for fiber-cement siding is

• acrylic latex paint

• vinyl acetate stain

• vinyl acrylic paint

• flat alkyd paint

One of the common practices used in creating a stucco finish is to

• fasten diamond mesh flat against the sheathing

• apply stucco in four coats

• apply stucco to a thickness of 3/4 inch

• use a stucco lock to prevent water penetration

Before vinyl siding installation, window sill extensions may be ut off to permit a flush fit for the

• starter strips

• J-cgabbek

• T-bevels

• siding caps