Table saws unit 211

What does PUWER is stand for?

• Provision and Use of Work Equipment Requirements

• Provision and Use of Work Equipment Regulations

• Provision and Use of Work Equipment Restrictions

• Prolonging and Use of Work Equipment Regulations

he extension table fitted at the back of a circular saw must not be positioned:

• Less than 1200mm from the centre of the saw

  blade

• Less than 1200mm from the riving knife

• Less than 1200mm from the saw teeth

• Less than 1200mm from the operator

What type of tooth pattern should a crosscut saw

have?

• Positive hook

• Negative hook

• Positive pitch

• Negative pitch

What does TCT stand for?

• Technically crafted tip

• Tungsten carbide tip

• Tungsten carbon tip

• Tensile carbon tip

What should be the minimum length of a push

stick?

• 400mm

• 425mm

• 350mm

• 450mm

What are positive tooth pattern saw blades

suitable for?

• Cutting along the grain

• Cutting deep cuts

• Cutting hardwoods

• Cutting across the grain

A saddle uses on a circular rip saw bench will

assist with:

• Deep cuts

• Angled cuts

• Using negative tooth pattern saws blades

• Using positive tooth pattern saw blades

What should you do if you find a circular saw

bench with a missing guard?

• Use the machine as long as long as you have told

  your employer

• Use the machine as long as you have been trained

• Not use the machine and report to your employer

  straightaway

• Not use the machine and carry on with another

  job

What is the most efficient form of dust collection

within a joiner’s workshop?

• Fixed ducted system

• Portable vacuum with hose

• Dust bag attached to machine

• Sweep up at end of job

The riving on a circular saw bench can act as a

form of:

• Safety switch

• Guard

• Support for the timber

• Guide for the timber