setting out

What scale is used on a detail drawing ?

• 1;5

• 1;10

• 1;50

• 1;100

Which one of the following could be used to take a measurement from an original drawing?

• Protractor.

• Scale rule.

• tape measure

• gauge rod

What ratio should be used when setting out a right angled corner?

• 1;2;4

• 2;3;4

• 3;4;5

• 3;5;7

When pouring concrete into foundation trenches, pegs can be used to ensure the correct

• level

• gauge

• dry

• wet

Which one of the following should be used when checking for gauge

• tape measure

• lines

• level

• trowel

A 90° angle can be established using a

• builders square

• straight edge

• timber

• spirit level

It is important to check the diagonal measurements when setting out to ensure the building is

• level

• plumb

• square

• straight

When transferring levels over a distance, a spirit level should be used with a

• builder’s square

• boat level

• trowel

• straight edge

Why should site clearance take place?

• To allow Building Inspectors time to inspect the site

• To ensure the site is ready for setting out

• To reduce the cost of removing the topsoil

• to help the bricklayers

Which one of the following describes the building line?

• a line from where you would joint up

• A line from which setting out will be taken, approved by the Local Authority.

• a line from what you would lay bricks

• A line from which setting out will be taken, approved by the HSE.