IED Final Review

In which step of the design process would you develop a design brief?

• Define the Problem

• Develop a Solution

• Generate Concepts

• Present the Solution

Which of the following is NOT an example of a deliverable?

• Engineering Notebook

• Design Brief

• Dimensioned Drawing Sheets

• Final Prototype

Which physical property would you use to calculate the amount of paint needed to paint the exterior of your hourse?

• Density

• Mass

• Surface Area

• Volume

What type of tolerance is shown in the image?

• Bilateral

• Unilateral

• Limit

• General

Which formula is used to calculate a tolerance value?

• Upper limit - lower limit

• Smallest hole - biggest axle

• Largest hole - smallest axle

• Lower Limit - Upper limit

These are the general tolerances provided on a drawing. What would be the upper limit for a specified dimension of 4.25?

• 4.35

• 4.26

• 0.020

• 4.46

Which type of tolerance is used for the overall height of this part?

• Limit dimensions

• Bilateral tolerance

• Unilateral tolerance

• Religious tolerance

The diameter of a hole is 0.50 ± 0.02. The pin that is inserted into the hole has diameter 0.53 ± 0.02. What is the allowance?

• 0.01

• 0.02

• 0.03

• 0.07

When a hole is always smaller than the part being placed inside of it, what type of fit is this?

• Clearance

• Interference

• Transition

• Tension

Which of the following is NOT an example of a physical property?

• Volume

• Density

• Surface Area

• Unit