Manufacturing routine joinery products

Which one of the following is not a health hazard?

• Dust

• Noise

• Saw blades

• Musculoskeletal

What scale are workshop rods usually drawn?

• 1:1

• 1:5

• 1:20

• 1:250

Name a document that is used for additional information that go's along-side of an architect's drawing?

• Specification

• Job sheet

• Schedule

• Building regulations

What's does the term 'nominal size' mean?

• Standard timber dimensions

• The planed timber dimensions

• The saw timber dimension before machining

• The total length of timber required

What Building regulation controls the rise and going of a staircase?

• Approved document A

• Approved document E

• Approved document G

• Approved document K

If a discrepancy is discovered between the setting out drawing and the building regulations, what action should you take?

• Contact the structural engineer

• Contact the architect

• Report the issue to your line manager or supervisor

• Amend the drawing

When should a cutting list be produced?

• After the setting out has been completed and checked

• Before producing the rod

• As soon as you receive the specification

• As soon as you receive the elevation drawings from the architect

Which one of the following machines is normally used first when preparing timber for routine joiner?

• Morticer

• Spindle moulder

• Rip saw

• Cross-cut saw

Which one of the following is a type of collective protective equipment?

• RPE

• LEV

• PPE

• CPD

What does the abbreviation LEV mean?

• Light extraction ventilation

• Long extraction ventilation

• Light exhaust ventilation system

• Local exhaust ventilation system