CCNA2 chapter 3

Which dynamic routing protocol was developed to interconnect different Internet service providers?

• BGP

• EIGRP

• OSPF

• RIP

Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?

• OSPF

• EIGRP

• RIP

• IS-IS

What two tasks do dynamic routing protocols perform? (Choose two.)

• discover hosts

• update and maintain routing tables

• propagate host default gateways

• network discovery

• assign IP addressing

When would it be more beneficial to use a dynamic routing protocol instead of static routing?

• in an organization with a smaller network that is not expected to grow in size

• on a stub network that has a single exit point

• in an organization where routers suffer from performance issues

• on a network where there is a lot of topology changes

When would it be more beneficial to use static routing instead of dynamic routing protocols?

• on a network where dynamic updates would pose a security risk

• on a network that is expected to continually grow in size

• on a network that has a large amount of redundant paths

• on a network that commonly experiences link failures

What is a purpose of the network command when configuring RIPv2 as the routing protocol?

• It identifies the interfaces that belong to a specified network.

• It specifies the remote network that can now be reached.

• It immediately advertises the specified network to neighbor routers with a classful mask.

• It populates the routing table with the network entry.

A network administrator configures a static route on the edge router of a network to assign a gateway of last resort. How would a network administrator configure the edge router to automatically share this route within RIP?

• Use the auto-summary command.

• Use the passive-interface command.

• Use the network command.

• Use the default-information originate command.

What is the purpose of the passive-interface command?

• allows a routing protocol to forward updates out an interface that is missing its IP address

• allows a router to send routing updates on an interface but not receive updates via that interface

• allows an interface to remain up without receiving keepalives

• allows a router to receive routing updates on an interface but not send updates via that interface

Which route would be automatically created when a router interface is activated and configured with an IP address?

• D 10.16.0.0/24 [90/3256] via 192.168.6.9

• C 192.168.0.0/24 is directly connected, FastEthernet 0/0

• S 192.168.1.0/24 is directly connected, FastEthernet 0/1

• O 172.16.0.0/16 [110/65] via 192.168.5.1

Refer to the exhibit. Which two types of routes could be used to describe the 192.168.200.0/30 route? (Choose two.)

• ultimate route

• level 1 parent route

• level 1 network route

• level 2 child route

• supernet route