Onshape Part Design

The first step in creating a new part is deciding which feature to create first. Once that decision is made, the next step is to decide which plane to sketch on.

• True

• False

In the image shown, which axis is normal to the Top plane?

• X-axis

• Y-axis

• Z-axis

• None of the above

Tags

CCSS.5.G.A.2

What features should be created first?

• Large Extrudes removing material

• Small Extrudes adding material

• Fillets and Chamfers

• Small Extrudes removing material

• Large Extrudes adding material

Which of the following does NOT affect a part’s design intent?

• The order in which features are created

• Which planes are used to create sketches

• Selecting the units for the part

• The direction that each feature is extruded

What is the minimum number of features required to create this part?

• 1

• 2

• 3

• 4

• 5

How many profiles must be selected in the sketch shown in order to create the single extrusion shown to the right of the sketch?

• 16

• 1

• 5

• 12

Tags

CCSS.HSG.MG.A.1

How many profiles must be selected in the sketch shown in order to create the raised circular extrusions shown in the center?

• 4

• 1

• 5

• 7

Tags

CCSS.HSG.MG.A.1

In order to create a multipart design within a part studio, the features cannot intersect because it causes interfering geometry.

• True

• False

In order to insert a multipart design into an assembly, each individual component must be selected from the Parts list to add each component one-by-one.

• True

• False

When adding a feature to a part, the Merge Scope can only be utilized if the new feature intersects the desired part.

• True

• False