Central Heating L2 6035 Plumbing

What is the Image shown (a)  

• Still
• Air Separator
• Bypass valve
• Slimline Boiler

What is Delta T

• Weight of the cistern

• The pump speed

• Room temperature divided by boiler temperature

• The difference between the temperature of the radiator and the room

What is this (a)  

• Radiator spanner
• Sonic screwdriver
• Tap wrench
• Pump adjustment key

Which radiator is a double panel double convector

• 
• 
• 
• 

Balancing a heating system requires you to adjust what (a)  

• The thermostat
• The TRV
• The lock shield
• The thermometer

Where is the neutral point

• At the edge of the Klingon empire

• Where the open vent connects to the circuit

• Where the primary flow becomes the return

• Where the cold feed connects to the circuit

The main problem with the one pipe system is that

• They are prone to blockages

• They can't be used in a bungalow

• They are expensive to run

• The earlier radiators pass cooler water back into the circuit

Wiring diagrams for the heating controls on a fully pumped system can be found in the (a)  

• Manufacturer’s Instructions
• British Standards
• NICEIC standards
• Wiring Regulations.

The cold water supply to a fully pumped open vented central heating system should be

isolated at the

• stop valve to the incoming cold water supply pipework

• Gate valve on the cold feed pipework from the F & E cistern

• service valve to the float operated valve to the CWS cistern

• service valve to the float operated valve to the F & E cistern.

The cold water supply to a fully pumped open vented central heating system should be

isolated at the

• stop valve to the incoming cold water supply pipework

• Gate valve on the cold feed pipework from the F & E cistern

• service valve to the float operated valve to the CWS cistern

• service valve to the float operated valve to the F & E cistern.