vehicle transmission and driveline units(a)

To disengage the clutch excessive force is required.what components should be checked first?

• Pedal,drive shaft ,transmission mounts and the master/slave cylinder

• Pedal mechanism ,clutch cable , release shaft m, master /slave cylinder and hose

• Clutch pressure plate , driven plate,flywheel face and master /slave cylinder

• Clutch driven plate ,input shaft splines, clutch cables, and master /slave cylinder

Which component provides the clamping pressure for the clutch shown in the image?

• 1

• 2

• 4

• 6

Which one of the following symptoms would a worm selector fork cause?

• Jumping out of gear

• Tranmssion judder

• Side cover oil leak

• Layshaft end float

What is used to check flywheel run out?

• Micrometer

• Set square

• Vernier caliper

• Dial test indicator

What could be damaged when a transmission unit is removed on some vehicles ?

• Suspension dampers

• Cylinder head

• Front cross member\

• Coolant pipes or connections

Which one of the following is a routine service task carried out on a hydraulically operated clutch mechanism?

• Adjusting the slave cylinder position

• Replacing the master cylinder seals

• Checking the fluid level in the reservoir

• Checking the condition of the flywheel face

Which component connects the rotating clutch to the release mechanism shown in the image?

• 7

• 6

• 4

• 3

A final drive has an input torque of 110Nm the pinion gear has 12 teeth and the crown wheel has 48 teeth.what will the output torque

• 30Nm

• 110Nm

• 440Nm

• 660Nm

What is one function of a clutch?

• Prevent two gears being selected at the same time

• Allow the driver to overrun the vehicle when travelling downhill

• Provide a means of increasing engine power as engine speed increase

• Control the torque transmitted from the engine to the engine to the transmission system

What is the main type of gear used in a synchromesh gearbox?

• Hypoid

• Spur

• Conical

• Helical