vehicle transmission and driveline units(d)

Which one of the following should be used to finally tighten flywheel bolts?

• An air wrench

• An impact wrench

• A torque wrench

• A rachet wrench

What is illustrated in the image shown?

• Reverse gear idler

• Gearbox interlock device

• Synchromesh selection unit

• Differential drive unit

What is the most accurate equipment to check the flywheel face for warping prior to replacing a clutch?

• Micrometer

• vernier caliper

• dial test indicator

• feeler gauge and straight edge

What type of final drive crown wheel gear is shown in the image?

• Spur

• Helical

• Hypoid

• Planet

What component holds the selected gear in mesh?

• Synchromesh hub

• Detent mechanism

• Selector fork

• Interlock mechanism

which one of the following applies to a clutch opearating cylinder ?

• it is sealed and never needs its fluid checking

• it is attached to the clutch release bearing

• it is attached to the clutch release bearing

• it used air as operating medium

Where does the half shaft transmit drive from?

• Differential sun gear to the wheel hub

• Differential planet gear to the wheel hub

• Pinion to the planet spindle and gear wheels

• Propeller shaft to the gearbox universal joints

What is the main type of gear used in a constant mesh gearbox?

• Bevel

• Helical

• Hypoid

• Spur

which gear will be selected by the circle component in the image?

• first gear

• third gear

• fifth gear

• reverse gear

What does a differential allow when a vehicle is travelling round a corner?

• Inner wheel to travel faster than the outer wheel

• Inner and outer wheels to travel at the same rate

• Wheels to automatically brake if speed is exceeded

• Outer wheel to travel faster than the inner wheel