MANUAL MILL SETUP

WHERE SHOULD AN OPERATOR PLACE ALIGNMENT PINS TO CORRECTLY ALIGN LARGE WORKPIECES CLAMPED DIRECLTY TO A WORKTABLE?

• ON A PARALLEL'S TOP SURFACE

• ON A PARALLEL'S SIDE

• ON THE X AXIS OF THE RIGHT SIDE OF THE WORKTABLE

• ON THE RIGHT SIDE OF THE VISE

WHAT FACTOR AFFECING CUTING SPEED SELECTION DESCRIBES THE EASE OF CUTTING A WORKPIECE MATERIAL?

• ITS COLOR

• ITS SIZE

• ITS MACHINABILITY

• ITS LENGTH

WHAT MANUAL MILLING PROCESS REQUIRES OPERATORS TO STUDY BLUEPRINTS, DETERMINE SETTINGS, ALIGN COMPONENTS AND SELECT CUTTING TOOLS?

• DEBRIEFING

• REBRIEFING

• TOLERANCE DETERMINATION

• PREPARATION

WHICH MILL COMPONENT MEASURES WORKABLE MOVEMENTS AS SMALL AS 0.0001 IN. (0.0025MM)?

• ANALOG READOUT

• DIGITAL READOUT

• ABACUS READOUT

• B-1 READOUT

WHAT TWO MANUAL MILL CUTTING VARIABLES DETERMINE THE VOLUME OF MATERIAL REMOVED PER MINUTE?

• FEED AND SIZE

• FEED AND CHIP LOAD PER TOOTH

• LENGTH AND TIME

• FEED AND TIME

ALONG WHICH CARTESIAN AXIS DOES A MILL'S WORKTABLE MOVE FROM SIDE TO SIDE?

• Y AXIS

• Z AXIS

• X AXIS

• O AXIS

WHAT TYPE OF MILLING FEEDS THE WORKPIECE AGAINST A CUTTING TOOL ROTATION?

• HORIZONTAL MILLING

• VERTICAL MILLING

• BOTH

• NEITHER

HOW SHOULD AN OPERATOR ALIGN A VISE WHEN USING IT AS A WORKHOLDING DEVICE? AN OPERATOR SHOULD ALIGN A VISE ALONG THE:

• Y AXIS

• S AXIS

• Z AXIS

• X AXIS

WHICH OF THE FOLLOWING COMPONENTS DOES AN OPERATOR USE TO CORRECT MILL HEAD ALIGNMENT ALONG THE Y AXIS?

• POSITIONING NUTSON SIDE OF THE V RAM

• V RAM

• SADDLE

• QUILL

WHICH OF THE FOLLOWING STATEMENTS ABOUT PART ZERO IS TRUE?

PART ZERO:

• MUST BE ESTABLISHED PRIOR TO WORKPIECE AND WORKHOLDING ALIGNMENT

• IS THE INTERSECTION OF TWO WORK LINES

• IS A REFERENCE POINT OF COORDINATES WHERE THE OPERATION STARTS

• NONE OF THESE