SAMTK Day 2

Which of the following statements correctly describes the function of a radiator cap?

• Valves inside the radiator cap regulate the pressure in the cooling system, thereby preventing damage to the system’s pipes and other components.

• A filter inside the radiator cap prevents rust and other foreign substances in the coolant from entering the radiator core.

• The radiator cap is triple-sealed to keep the cooling system completely airtight.

• A temperature sensor in the radiator cap sends coolant temperature signals to the PGM-FI unit.

Which of the following statements correctly describes the flow of coolant immediately after a cold engine is started?

• The coolant circulates through the radiator and cylinder block.

• Until the engine warms up, the coolant circulates through the

  water jacket but does not flow into the radiator.

• No coolant circulation takes place until the engine has warmed up.

• The coolant is circulated only through the radiator.

Which one of the following components is responsible for converting

the rotation of the steering wheel into lateral motion?

• Steering wheel

• Steering shaft

• Steering gearbox

• Tie rod

Power Steering System is designed for

• effort to turn the steering wheel can be reduced when driving at low speed and parking

• effort to turn the steering wheel can be increased when driving at high speed

• effort to turn the steering wheel can be reduced when driving at high speed

• effort to turn the steering wheel can be increased when driving at low speed and parking

Which one is the function of suspension?

• To ensure the wheels are always firmly in contact with the road surface.

• To ensure that the steering wheel can deliver a suitable amount of steering force.

• To ensure that wheel alignment is not disturbed during driving.

• To automatically correct effects of over-steering.

In what case is the use of rigid suspension beneficial?

• When it is desired to reduce the unsprung mass.

• When it is desired to improve tire-to-ground contact characteristics.

• When it is desired to have more flexibility in design.

• When large changes in load make it necessary to have a large suspension stroke.

What is the main function of torque converter?

• To transfer the engine’s output power to the gear unit through the action of a special fluid.

• To enable a transmission efficiency of 100% to be achieved.

• To control the hydraulic pressure.

• To enable shifting of gears within the range selected by the driver, performed automatically.

What is the result of an increase in the Drive Pulley diameter and

a decrease in the Driven Pulley diameter?

• High gear ratio

• Low gear ratio

• No effect

• Middle gear ratio

Where is the manufacturing plant of Honda Access wheel lock nut?

• USA

• Japan

• Malaysia

• Thailand

Service Advisor needs to advise the customer on changing tires when it reaches mm?

• 1.6 mm

• 2.0 mm

• 2.5 mm

• 4.5 mm