Switch Config and Connectivity

Which statement is true about the running configuration file in a Cisco IOS device?

• It is automatically saved when the router reboots

• It should be deleted using the erase running-config command

• It affects the operation of the device immediately when modified

• It is stored in NVRAM

Which two statements are true regarding the user EXEC mode? (Choose two.)

• All router commands are available

• Global configuration mode can accessed by entering the enable command

• the device prompt for this mode ends with the ">" symbol

• interfaces and routing protocols can be configured

• Only some aspects of the router configuration can be viewed

Which type of access is secured on a Cisco router or switch with the enable secret command?

• Virtual terminal

• console line

• privileged EXEC

• AUX port

When a hostname is configured through the Cisco CLI, which three naming conventions are part of the guidelines? (Choose three.)

• The hostname should be written in all lower case characters

• The hostname should contain no spaces

• the hostname should begin with a letter

• the hostname should be fewer than 64 characters in length

• the hostname should end with a special character

A router with a valid operating system contains a configuration file stored in NVRAM. The configuration file has an enable secret password but no console password. When the router boots up, which mode will display?

• setup mode

• privileged EXEC mode

• global configuration mode

• user EXEC mode

Which memory location on a Cisco router or switch will lose all content when the device is restarted?

• ROM

• flash

• RAM

• NVRAM

Why would a technician enter the command copy startup-config running-config?

• To remove all configurations from the switch

• to make a changed configuration the startup configuration

• to copy the existing configuration into RAM

• to save an active configuration into NVRAM

Which memory location on a Cisco router or switch stores the startup configuration file?

• ROM

• RAM

• flash

• NVRAM

What is the command to assign the name “Sw-Floor-2” to a switch?

• hostname Sw-Floor-2

• host name SW-Floor-2

• name Sw-Floor-2

How is the privileged EXEC mode access secured on a switch?

• enable class

• secret class

• enable secret class

• service password-encryption