Which of the following is the meaning of the abbreviation "AcoP

• Approved code of practice

• Approved code of product

• Approved method of work

• Approved case of practice

Which of the following reasons is why a start button is recessed?

• to prevent accidental starting of the machine.

• to prevent the machine being switched off before finishing the work.

• to allow you to stop the machine.

• to look more aesthetically pleasing in design.

The purpose of the riving knife at the rear of the cutting blade is to ?

• to smooth out the cut sides of the timber.

• prevent the timber binding on the cutting blade.

• Cut the timber faster

• Keep the blade from wobbling.

Which of the following are kinds of cuts that can be done on a circular table saw? (Pick 2)

• Flatting

• Deeping

• Scarfing

• Slicing

Which of the following regulations relate specifically to the use of circular saws?

• PUWER

• HASAWA

• RIDDOR

• COSHH

Which circular saw component is shown in the image?

• Riving knife

• Crown guard

• Top guard

• Blade shim

Which of the following would be considered a "fault" when using a circular bench saw?

• Top guard (crown guard) close to the work-piece.

• Rip fence pulled back during cross cutting of timber.

• Lubricant sprayed on the bed of the saw.

• Riving knife that has been fitted is thinner than the saw blade.

Which of the following is the component shown in the image?

• Blade depth adjustment wheel

• Back fence

• Start stop switch

• Top guard (crown guard.)

Which of the following is the component shown in the image?

• Depth adjustment wheel

• Back fence

• Start stop switch

• Top guard (crown guard.)

Which of the following is the component shown in the image?

• Depth adjustment wheel

• Back fence

• Start stop switch

• Top guard (crown guard.)