Evaluation in Technical Drafting

1. In Technical Drafting laboratory, its main purpose is to provide you a place where you can fasten your paper.

• A. drawing pencil

• B. drawing table

• C. eraser

• D. masking tape

2. This type are in different forms, materials in technical drafting where you placed your drawings.

• A. drawing paper

• B. drawing pencil

• C. eraser

• D. masking tape

3. Usually it has grade 1, 2 and 3. This is one of the most important tools in drawing. It comes in various grades.

• A. drawing pencil

• B. drawing table

• C. eraser

• D. masking tape

4. Usually it comes in different shape. This is used to clean the dirt off the drawing.

• A. drawing pencil

• B. drawing table

• C. eraser

• D. masking tape

5. This is used for fastening the drawing paper on the drawing table or drawing board because it does not damage the board and it will not damage the paper if it is removed by pulling it off.

• A. drawing paper

• B. drawing pencil

• C. eraser

• D. masking tape

6. It is a drawing instrument used when making horizontal lines. It is also used for guiding triangles when drawing vertical lines.

• A. compass

• B. divider

• C. triangle

• D. T-square

7. This drawing instrument is used when drawing arcs and circles

• A. compass

• B. divider

• C. triangle

• D. T-square

8. It is a three-sided ruler, which typically has two equal sides meeting at a 90 degree angle and to a third side at 45, 30, including 60 degree angles

• A. compass

• B. divider

• C. triangle

• D. T-square

9. This is a drawing instrument used when transferring measurements, dividing lines and arcs into the desired number of equal parts.

• A. compass

• B. divider

• C. protractor

• D. triangle

10. I would like to draw an arc. It is a semi-circular instrument divided into 180 equal parts, each of which is called a degree.

• A. compass

• B. divider

• C. protractor

• D. triangle