Getting familiar with EV3

Which of the following CANNOT be used for providing power to the EV3

• 6 AA batteries

• 6 AAA batteries

• Ev3 rechargable DC battery

• The ev3 accepts any of the listed sources

What is Firmware?

• A special type of software that allows the EV3 to understand the programs you write

• A special type of software used by law firms

• The parts of the robot that are not flexible

• The physical appearance of the robot

How do you turn on the EV3

• Left Button

• Right Button

• Center Button

• Top Button

Motor (output) ports are identified using ____

• Numbers 1, 2, 3, 4

• Letters A, B, C, D

• Numerals I, II, III, IV

• USB and PC Ports

Sensor (Input) ports are identified using ____

• Numbers 1, 2, 3, 4

• Letters A, B, C, D

• Numerals I, II, III, IV

• USB and PC Ports

How do you turn off the EV3 properly?

• Remove the rechargable battery

• Press and hold the Left and Right Buttons for 5 seconds

• Press the Back button until a Shut Down dialog appears, then select the checkbox with the center button

• Insert the Sut Down USB adapter into the USB port on the side of the EV3

How do you navigate the menus of the EV3

• Touch the screen with an included stylus pen

• Use the lego IR remote

• Use the direction buttons to navigate, Center button to select, back button to cancel or go back

• Use the Sound sensor and the built-it voice commands

To run a program from the Run Recent menu, what do you do?

• Run Recent (first tab) > Select the program then press the center button

• File Navigation (second tab) > Select the Project > Select the Program

• Brick Apps (third tab) > Port View > Select the motor or sensor that you just recently used to run that program

• Settings (fourth tab) > Brick Info > Recently Run, then use the center button to select

To run a program from the File Navigation menu, what do you do?

• Run Recent (first tab) > Select the program then press the center button

• File Navigation (second tab) > Select the Project > Select the Program

• Brick Apps (third tab) > Port View > Select the motor or sensor that you just recently used to run that program

• Settings (fourth tab) > Brick Info > Recently Run, then use the center button to select

How do you check the motor and sensor values on the EV3?

• Plugging the EV3 into the computer and using the EV3 Software to check

• Using the Brick Apps (third menu) > Port View > Select the motor or sensor you want to view

• Adding a block to display the motor/sensor value when running a program

• Attaching a second screen adapter to the USB Port on the side of the EV3