Router Table Safety Test

The router table should be unplugged when making any adjustments to the bit or fence.

• True

• False

It is ok to run material through the router in both directions as long as proper guards and hand positions are utilized.

• True

• False

Long hair must be tied back, and loose jewelry must be removed when using the router table.

• True

• False

It is the student’s responsibility to ensure the tightness of the bit prior to use of the router table.

• True

• False

Any hazards or safety concerns regarding the safe operation of the router table should be reported immediately to the teacher.

• True

• False

It is ok to make a second pass with your material on the router table to ensure a smooth and consistent edge profile.

• True

• False

It is unsafe to use push sticks when routing thin material

• True

• False

It is important to keep fingers outside of the red safety zone, or a minimum of _____ inches away from the router bit at all times

• 6 inches

• 3 inches

• 2 inches

• 4 inches

When using the router table, your _______ hand should be guiding the material while providing downforce, and your ________ hand should be keeping the material tight against the fence and pushing it past the bit.

• Left, Right

• Right, Left

• Dominant, Non-Dominant

Some router bits are equipped with a _______________ which allows the bit to ride along the material and only remove a designated amount of material. These should be checked for wear prior to use.

• Bit guide

• Bearing

• Roller wheel

• Bit assist