Test - FT Heritage - Advance Service Training

Valve Clearance value for Inlet & Exhaust valve of FT 6050 Engine is

• 0.30 mm & 0.40 mm

• 0.20 mm & 0.30 mm

• 0.40 mm & 0.60 mm

• 0.80 mm & 1.00 mm

To set the FIP Timing in FT 6050 Engine

• Insert the pin in 1st Hole of Flyweel

• Insert the pin in 2nd Hole of Flyweel

• Set the Flywheel mark at 13 Degree

• Set the Flywheel mark at 0 Degree

Gear assembling order in Main shaft of FT Heritage 8+2 Gearbox is

• R,1,2 & 3

• 2,R,1 & 3

• 1,2,3 & 4

• All of the above

Recommended Sealant in Housing Joints of FT Gear box ,Rear axle anfd Hydraulic is

• Paper Gasket

• Anabond 666

• Loctite 5182

• Threebond 4252

When hydraulic lift circuit is in neutral, which valve will be in open condition

• Control valve

• Unload valve

• Cylinder safety valve

• Pressure relief valve

Draft Spring Adjustment value in FT Heritage models Hydraulics is

• 3.25 - 5.5 mm

• 1.12 - 1.40 mm

• 0.30 -0.40 mm

Mention the name of given valve

• Control valve

• Unload Valve

• Cylinder safety valve

• Check valve

Which Type of Rear axle reduction used in FT 6050 Heritage

• 
• 
• 

To adjust position and draft control linkage ( Control valve adjustment) in FT Heritage hydraulics , the lift arm should be kept in

• Upper position

• Lower Position

• In any Position

Pinion bearing preload in FT 6075 Heritage & FT 6050 Heritage should be

• 4 – 6 Kgf

• 7 - 9 Kgf

• 2 – 4 Kgf

• 10-12 Kgf