Exam CCNA Part 2

Refer to the exhibit. An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the

GigabitEthernet3/1/4 port on a switch?

• The phone and a workstation that is connected to the phone send and receive data in VLAN 50.

• The phone sends and receives data in VLAN 50, but a workstation connected to the phone has no VLAN connectivity

• The phone sends and receives data in VLAN 50, but a workstation connected to the phone sends and receives data in VLAN 1.

• The phone and a workstation that is connected to the phone do not have VLAN connectivity

Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

• passive

• active

• auto

• mode on

Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. What is the reason for the problem?

• The OSPF process IDs are mismatched.

• The OSPF router IDs are mismatched.

• Router2 is using the default hello timer.

• The network statement on Router1 is misconfigured.

Refer to the exhibit. What is the next hop address for traffic that is destined to host 10.0.1.5?

• 10.0.1.50

• 10.0.1.4

• Loopback 0

• 10.0.1.3

Refer to the exhibit. An extended ACL has been configured and applied to router R2. The configuration failed to work as intended. Which two changes stop

outbound traffic on TCP ports 25 and 80 to 10.0.20.0/26 from the 10.0.10.0/26 subnet while still allowing all other traffic? (Choose two)

• The source and destination IPs must be swapped in ACL 101

• The ACL must be configured the Gi0/2 interface inbound on R1.

• Add a "permit ip any any" statement at the end of ACL 101 for allowed traffic.

• Add a "permit ip any any" statement to the beginning of ACL 101 for allowed traffic

What is the effect when Ioopback interfaces and the configured router ID are absent during the OSPF Process configuration?

• The lowest IP address is incremented by 1 and selected as the router ID.

• The highest up/up physical interface IP address is selected as the router ID.

• No router ID is set, and the OSPF protocol does not run.

• The router ID 0.0.0.0 is selected and placed in the OSPF process.

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

• auto

• on

• active

• desirable

Refer to the exhibit. How does the router manage traffic to 192.168.12.16?

• It chooses the EIGRP route because it has the lowest administrative distance.

• It load-balances traffic between all three routes.

• It selects the RIP route because it has the longest prefix inclusive of the destination address.

• It chooses the OSPF route because it has the longest prefix inclusive of the destination address.

Refer to the exhibit. Router R2 is configured with multiple routes to reach network 10.1.1.0/24 from router R1. What protocol is chosen by router R2 to reach the

destination network 10.1.1.0/24?

• OSPF

• static

• eBGP

• EIGRP

Refer to the exhibit. Which route type is configured to reach the internet?

• network route

• floating static route

• default route

• host route