Cisco_Sem2_Mod6

True or False, there are two main types of fly fishing, wet and dry?

• False

• True

A link aggregation technology is needed that allows redundant links between devices that will not be blocked by

When an EtherChannel is configured, the resulting virtual interface is called a what channel?

• Port channel

• Harbour Channel

• Link Channel

• Channel tunnel

Select ALL the advantages of EtherChannel

• EtherChannel relies on existing switch ports. There is no need to upgrade the link to a faster and more expensive connection to have more bandwidth

• Load balancing takes place between links that are part of the same EtherChannel

• EtherChannel provides redundancy because the overall link is seen as one logical connection. Additionally, the loss of one physical link within the channel does not create a change in the topology

• Most configuration tasks can be done on the EtherChannel interface instead of on each individual port, ensuring configuration consistency throughout the links

True or False, Fast Ethernet and Gigabit Ethernet cannot be mixed within a single EtherChannel

• True

• False

The Cisco Catalyst 2960 Layer 2 switch currently supports up to how many EtherChannels. ​

• 2

• 4

• 6

• 8

EtherChannels can be formed through negotiation using one of two protocols, select BOTH

• Aggregation Protocol (PAgP)

• Alteration Protocol (PAgP)

• Link Aggregation Control Protocol (LACP)

• Link Alteration Control Protocol (LACP)

True or False, In EtherChannel, it is mandatory that all ports have the same speed, duplex setting, and VLAN information. Any port modification after the creation of the channel only changes that channel.​

• True

• False

True or False, if Link Aggregation Control Protocol (LACP) mode setting on two connected switches is set to Passive a channel will be established

• True

• False

What does EtherChannel support mean?

• Configure all interfaces in an EtherChannel to operate at the same speed and in the same duplex mode

• All interfaces in the EtherChannel bundle must be assigned to the same VLAN or be configured as a trunk

• All Ethernet interfaces must support EtherChannel with no requirement that interfaces be physically contiguous

• Ether what?!