Post Test Day 2

The network administrator wants to improve the performance of network transmission, what steps can the administrator take? (Choose two)

• Change the work mode to full duplex of each end station

• Link the end stations together using a switch

• Change the work mode to half duplex of each end station

• Link end stations together using a hub

A network administrator recently used tracert to trace the path to the destination IP address of an external website, however the trace path displayed only a timeout result. Which of the following statements correctly explains the reason for this? (Choose two)

• The source router had shutdown the ICMP function

• This destination IP address does not exist

• The gateway cannot find a route to the destination

• This is a normal phenomenon

Which of the following applications can be used to detect the path along which the data packets are transmitted from the source to the destination?

• Route

• Netstat

• Tracert

• Send

Which of the following commands can be used to display the routing table on a router?

• display ip path

• display ip routing-table

• display interface

• display current-configuration

Which of the following entries is not included in the routing table?

• source address

• next hop

• destination address

• cost

An administrator wishes to manage the router in the remote branch office, which method can be used?

• Telnet

• FTP

• Console Connection

• DHCP

A user logged into a VRP supported device through telnet, but when attempting to configure the device, found that he is unable to use the system- view command to enter the system-view.

What are the possible reasons for this? (Choose two)

• The device's VTY interface only provides permission for some telnet users to run the system-view command

• The user's telnet software restricts use of this command

• The user's privilege level is lower than the level associated with the system-view command

• The system-view command privilege level is lower than the level associated with the user

Which of the following OSPF versions are suitable for IPv6?

• OSPFv2

• OSPFv3

• OSPFv4

• OSPFv1

Which of the following about the statement of static routing are incorrect?

• Manual configuration by network administrator

• Inter-route information needs to be exchanged between routers

• Can not automatically adapt to changes in network topology

• Low system performance requirements

For multiple paths to the same destination network, the router needs to select by comparing the

size of the Preference value, If the Preference is the same, then select according to the size of the

Cost value.

• True

• False