SMAW - Open-Root Groove Welds - Plate

If a groove only goes part of the way through the joint, welding in the groove results in what is called a ____.

• J weld

• fillet weld

• backing weld

• partial joint penetration (PJP) weld

The portion of the edge of a part to be joined by a groove weld that has not been beveled or

grooved is called the ____.

• root face

• bevel face

• joint root

• groove angle

For long-term cutting or welding of materials containing cadmium, wear ____.

• an approved full-face, supplied air respirator

• a metal fume filter

• a HEPA-rated filter

• a standard cotton filter

For an open-root V-groove weld, the thickness of the root reinforcement should be no more

than ____.

• 1/32" (0.8 mm)

• 1/16" (1.6 mm)

• 1/8" (3.2 mm)

• 3/16" (4.8 mm)

When the plates are vertical but the axis of the weld is horizontal, the code for this position

of groove weld is ____.

• 1G

• 2G

• 3G

• 4G

Groove welds should be made with a gradual transition to the base metal at each ____.

• weld root

• throat

• toe

• root opening

When using weave beads in flat open-root V-groove welds, use a ____.

• 10- to 15-degree drag angle

• 15- to 20-degree drag angle

• 10- to 15-degree push angle

• 35- to 40-degree push angle

When welding open-root V-groove welds in the horizontal position, do not ____.

• feather tack welds with a grinder

• use weave beads

• chip and clean each pass

• use stringer beads

Which of the following positions is done using a push angle instead of a drag angle?

• 1G

• 2G

• 3G

• 4G

To prevent undercut in a vertical open-root V-groove weld, the welder should ____.

• increase the arc length

• use a downward push angle

• use a 30-degree drag angle

• pause slightly at each weld toe