BMK Ultra Plus Quiz-D3

1. Which of the following actions you must do before replacing UV sleeve and UV bulb during PM.

Choose all that apply.

• Turn off power of instrument and unplug the power cable of instrument, wait for 15mins to cool down the UV bulb.

• Turn on waste direct valve in waste capture module to drain the waste

• Drain the waste in weir trap through the ball valve

• Wear gloves before handling

2. What are the new components found in Ultra Plus waste capture module?

Choose all that apply.

• LCS waste direct valve

• LCS Ultrasonic waste sensor

• 20L waste carboy detect sensor

• Carboy locking cylinder

3. Which components need to replace during PM?

Choose all that apply.

• Compressor muffler and silencer

• High pressure inline check valve

• Reservoir inline filters

• UV bulb and sleeve

• Exit manifold overflow screws

4. What is the function of UV sensor?

• Acts as a barrier between waste fluid and the UV bulbtion 1

• Generate UV light to degrade or neutralize the waste

• Monitors the UV wavelength of the bulb and will cause an error message if the signal is too low

5. What are the functions of the Audible alert PCB?

• Provide I/O to status lights.

• Power to the integrated touchscreen LUI monitor

• Power to the Reagent hood solenoid

• Power to the Reagent hood sensor

6. In Ultra Plus installation procedure, we need to pour DI water into weir trap,

how to do this action?

• Pour DI water from waste tub

• Pour DI water from waste tub first, then UV system

• Pour DI water from UV system

• Pour DI water from UV system first, then waste tub