Introduction to Robotics

The number of independent directions or joints of the robot, which would allow the robot to move its end effector through the required sequence of motions.

 

• A.      On-Line programming

• B.      Operator

• C.      Degrees of freedom

• D.      Error

Tags

NGSS.MS-PS2-1

.   An information processing device whose inputs are both the desired and measured position, velocity or other pertinent variables in a process and whose outputs are drive signals to a controlling motor or actuator

 

• A.      Economy

• B.      HAZARDOUS MOTION

• C. JOINTS

• D.  Controller

Tags

NGSS.MS-ETS1-4

NGSS.MS-PS2-1

is a correction factor for data that establishes an indicated value of zero when the robot is at the predetermined Home (calibration position).

• A.      Burn-In

• B. ABSO Data

• C. Gripper

• D. Operator

Respond to physical stimuli (such as heat, light, sound, pressure, magnetism, motion) and transmit the resulting signal or data for providing a measurement, operating a control, or both

• A.      Robot

• B.      Sensor

• C. Gripper

• D. Joints

A device that produces a coherent monochromatic beam of light which is extremely narrow and focused but still within the visible light spectrum

• A.. Gripper

• B.      Joints

• C.      Sensor

• D.      Laser

Tags

NGSS.MS-PS4-2

A programming method where the task program is defined on devices or computers separate from the robot for later input of programming information to the robot

• A. On-Line programming

• B.   Solar Power

• C.      Off-Line programming

• D.      Geothermal Power

Unintended/unexpected robot motion that may cause injury

• A.      Burn-In

• B. Hazardous Motion

• C. malfunction

• D. Biogas

Tags

NGSS.MS-ETS1-2

NGSS.MS-ETS1-4

NGSS.MS-PS2-5

.  Is the measurement of the deviation between the command characteristic and the attained characteristic, or the precision with which a computed or calculated robot position can be attained.  

 

• A.      Dynamics

• B. Command Position

• C. Expandability

• D. Accuracy

Tags

NGSS.MS-PS2-2

A re-programmable, multifunctional manipulator designed to move material, parts, tools, or specified devices through variable programmed motions for the performance of a variety of tasks

• A.      Dynamic

• B.   Robot

• C.   Command position

• D.  ABSO Data

Tags

NGSS.MS-ETS1-1

NGSS.MS-ETS1-2

NGSS.MS-ETS1-3

NGSS.MS-ETS1-4

NGSS.MS-PS2-1

.  The person designated to start, monitor and stop the intended productive operation of a robot or robot system. An operator may also interface with a robot for productive purposes

 

• A. On-line programming

• B. Operator

• C. Degrees of freedom

• D. Error