N5 D&M Revision Quiz

Which of the following is a light coloured hardwood?

• Oak

• Mahogany

• MDF

• Pine

Which of the following is the correct order to prepare a wooden blank for turning?

• 1.Mark diagonals on each end.

  2.Plane off the corners down to the marked circle.

  3.Mark off each centre with a bradawl.

  4.Mark a circle of maximum diameter on each end.

  5.On one end cut down one of the diagonals to a depth of 2mm with a tenon saw.

• 1.Mark diagonals on each end.

  2.Mark off each centre with a bradawl.

  3.Mark a circle of maximum diameter on each end.

  4.On one end cut down one of the diagonals to a depth of 2mm with a tenon saw.

  5.Plane off the corners down to the marked circle.

• 1.Mark a circle of maximum diameter on each end.

  2.Plane off the corners down to the marked circle.

  3.Mark off each centre with a bradawl.

  4.On one end cut down one of the diagonals to a depth of 2mm with a tenon saw.

  5. Mark diagonals on each end.

Which tool is used to measure the diameter of a piece of wood?

• Outside Callipers

• Inside Callipers

• Odd Leg Callipers

• Steel Rule

Why is the grain glued in different directions when laminating planks of wood?

• To make it look nicer

• So the glue sticks better

• To stop the board warping

• To make the width larger

How can you check that a prototype is square when its finished? (choose 2)

• Use a compass

• Measure corner to corner to check measurements are the same

• Look at it and check it looks square

• Use a try square

How would you apply varnish?

• Use a clean brush and work in the direction of the grain

• Rub on with a clean cloth against the grain

• Use a clean brush and work against the grain

• Rub on with a clean cloth in the direction of the grain

Which of the following are properties of steel?

• Strong, yellow coloured and corrosion resistant

• Strong, durable and corrosion resistant

• Strong, durable and can be bent into different shapes

• Scratch proof, durable and corrosion resistant

How would steel bar be formed into a rounded shape?

• Heat steel in an oven then hit it round a former with a ball pein hammer. Quench in water to cool.

• Use bending bars and a ball pein hammer to hit it into shape

• Secure it in a vice and hit it into shape with a mallet

• Heat steel in a forge then hit it round a former with a ball pein hammer. Quench in water to cool.

What is the correct order for finishing the edges of plastic?

• draw file

  cross file

  emery cloth

  wet and dry used dry wet and dry used damp

  polish

• cross file

  draw file

  emery cloth

  wet and dry used dry wet and dry used damp

  polish

• emery cloth

  cross file

  draw file

  wet and dry used dry wet and dry used damp

  polish

• emery cloth

  cross file

  draw file

  wet and dry used damp

  wet and dry used dry

  polish

What type of drill bit is this?

• Auger

• Flat

• Fostner

• Twist