Module 15: R&S-Static Routing

What is the administrative distance of a static route?

• 0

• 1

• 2

• 10

What is the administrative distance of a directly connected route?

• 0

• 1

• 2

• 10

What is the purpose of the 0.0.0.0 0.0.0.0 10.10.1.1 command?

• To provide a default route for any non-matching network destination.

• To create a static route for the 10.10.1.1 network.

• To create a dynamic route for the 10.10.1.1 network.

• To create a default gateway address for PC's to forward packets.

What is the purpose of adding an administrative distance number to the end of a static route? 

• To create a standard static route.

• To create a default static route.

• To create a floating route.

• To create a summary static route.

Which factor determines the best path to forward a packet when there are multiple paths available to a destination network using the same routing protocol?

• Lowest metric

• Lowest administrative distance

• Order of the paths in the routing table

• Priority value of protocol

Which of the following are used to configure the destination network portion of an IPv6 static route?

• Network prefix and prefix length

• Network prefix and subnet mask

• Source IP address

• Destination IP address

What is a characteristic of a floating static route?

• When it is configured, it creates a gateway of last resort.​

• It is simply a static route with 0.0.0.0/0 as the destination IPv4 address.

• It is a backup route configured with a higher administrative distance than the original destination route.

• It is used to provide load balancing between static routes.

Which of the following commands should be used before configuring IPv6 routes?

• router EIGRP

• router OSPF

• ip routing

• ipv6 unicast-routing