Random Plumbing 02

When a union is provided for an appliance connected by rigid metallic pipe, the union shall be accessible and located within ___________________feet of the appliance.

• 2
• 3
• 4
• 6
• 411.1.6 IFGC

A __________ is not required for a sewage sump and ejector.

• pump alarm
• vent
• check valve
• full open valve
• 712.2 and 712.3.2

When required to discharge to a combined building sewer system, floor drains in a __________ are not required to be individually trapped.

• food preparation facility
• multilevel parking garage
• warehouse
• factory
• 1002.1, Exception 4

An indirect waste pipe that discharges through an air break must terminate above the __________ of the waste receptor.

• flood level rim
• trap seal
• critical level
• strainer dome
• 802.3.2

Where tests are required as evidence of compliance with the code, the test reports code, the test reports shall be retained for __________. shall be retained for __________. shall be retained for __________.

• 180 days after completion of the project
• the period required for retention of public records
• 90 days after completion of the project
• 120 days after occupancy of the building
• 105.3.3

When a plumbing permit is issued, the construction documents shall be stamped __________.

• APPROVED FOR CONSTRUCTION
• APPROVED
• ACCEPTED AS REVIEWED
• REVIEWED FOR CODE COMPLIANCE
• 106.5.1

Floor drains in walk-in refrigerators of food establishments shall be __________.

• directly connected to the drainage system
• connected to the drainage system protected with a backwater valve
• y connected to the drainage system by means of an air gap
• y connected to the drainage system by means of an air break
• 802.1.2

Appliance connections to a chimney or vent equipped with a power exhauster shall be made on the ______________ side of the exhauster.

• outlet
• inlet
• positive
• discharge
• 501.1 IFGC

If a water purveyor were unable to provide a water supply at flow pressures sufficient to supply the minimum required pressures at the fixtures, all of the following would be a suitable resolution, except __________.

• Oversizing the water distribution piping system
• A hydropneumatic pressure booster system
• a water pressure booster pump system
• An elevated supplemental water supply
• 606.5.1

A 4-inch by 3-inch water closet flange is __________.

• not considered a reduction in size
• prohibited
• an offset fitting
• required
• 704.2