Trial Test pt 1

Dew point is the temperature at which

• Water freezes

• Humidity decreases

• Condensation occurs

• The air is saturated

Upon arrival of coating materials, the inspector should

• review coating contractors' plans for storage of coating materials and confirm they meet national, local and owners' fire and environmental regulations.

• observe and document time frame and environmental conditions between each coat.

• observe and document the amount of material and batch numbers.

• observe aryl document that the applicator WFT at regular intervals during application.

Galvanic corrosion occurs on which of the following substrates:

What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

Inspection documentation is important because

• It is the only deliverable item provided by the inspector

• Owners use the documentation for a variety of purposes

• The answer in (a) only

• Both answers from (a) and (b)

You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors. Your FIRST preferred course of action is to:

• Meet with the prospective employer to determine the scope of your role

• Review the NACE Attestation prior to making a decision

• Accept the assignment without hesitation

• Advise the prospective employer that you cannot accept the position

Non Conformance Reports are completed by the Inspector:

• In every instance that an item does not meet the specification requirements

• When the Inspector deems it to be a significant non-conforming item

• In accordance with the specification's definition of a non-conformance

• When the Inspector and Contractor deem it to be a significant non-conforming item

The form of corrosion that has the largest potential for unexpected catastrophic failure is:

​ "​ " can cause osmotic blistering

• inadequate anchor pattern/surface profile

• applying tine coating too thin

• airless spray application

• overcoating a surface contaminated with chemical salts.