Battery Connectors

What can you do to determine or remember what is positive or negative terminal if they are the same color?

• A. It is advisable and wise to use steel stamps to remember what terminal it is.

• B. It is advisable to use a cable detector.

• C. Use a metal detector.

• D. It is wise to mark them with the correct sign and use a multimeter tester to make sure it’s correct.

What happens if the positive battery cable is loose?

• A. It can cause corrosion around the battery terminal.

• B. It can cause the battery to explode because the electricity passing is not correct.

• C. It can make the electricity passing through the system weaker.

• D. Nothing will happen.

Where is the negative cable other end connected to?

• A. Fuse Box

• B. Electric System

• C. Body of the Vehicle

• D. Alternator

What must be the characteristics of the new connector cables?

• A. Same length and size

• B. Compatible with the car

• C. Matching terminal ends

• D. All of the above

Why do you need to trim the wire on the correct size?

• A. To ensure that all batteries are working equally

• B. To the reliability and consistency of the system.

• C. To avoid leakage in the battery.

• D. To make it run slower.

There are a lot of reasons why we need to replace or repair the battery terminal, except:

• A. Overcharging

• B. Electrolyte leakage

• C. Overfilling the battery

• D. Hardware failure

What are the components of the mixture used to clean battery connectors?

• A. Dishwashing liquid and water

• B. Baking soda and water

• C. Water only

• D. Baking soda, dishwashing liquid and water

Judoi is cleaning his car's battery connectors. He is done brushing his battery connectors using water and baking soda. What should he do next?

• A. Apply vaseline gel or anti-corrosion pads

• B. Make a mixture o water and baking soda

• C. Wipe thoroughly the excess water and baking soda

• D. Inspect the connectors and battery

Why do you need to properly connect the cables or wire to the terminal?

• A. It slow more and consequently undergo more bending than the longer wavelengths.

• B. To avoid the device heating up and causing fire.

• C. To create greater capability to run simultaneously more program without slowing down.

• D. The amount of energy is directly proportional to the photon's electromagnetic frequency

Why should the wires to the terminal connected the same formation the original part does?

• A. Because batteries won't respond to misaligned wiring

• B. Because it only works when it's upward

• C. Because wiring mishaps might lead to drained batteries or no power at all.

• D. A and C